Die springs
|
Mode |
Tool |
Workspace: Tool set |
|
Modes for Tworzenie pojedynczej linii Modes for Narzędzie Wstaw symbol |
Die Spring
|
Architect and Spotlight: Machine Components Landmark: Add tool to workspace
|
The Die Spring tool and Die Spring - 3D tool share the same position on the tool set. Click and hold the mouse on the visible tool to open the Narzędzia ukryte list and select the desired tool.
The 2D die spring is a linear object, while the 3D die spring is a point object.
Die springs are made of rectangular wire.
To insert a die spring:
Click the tool and mode.
Kliknij, aby pokazać/ukryć parametry. place the object, and click again to set the rotation. The first time you use the tool in a file, a properties dialog box opens. Set the default parameters. The parameters can be edited later from the Object Info palette.
Kliknij, aby pokazać/ukryć parametry.Kliknij, aby pokazać/ukryć parametry.
|
Parameter |
Description |
|
Fits into Hole |
The spring will be able to fit into a hole of this diameter |
|
Fits over Shaft |
The spring will be able to fit over a shaft of this diameter |
|
Wire Width |
Specify the width of the wire |
|
Wire Height |
Enter the height of the wire |
|
Solid Height |
Enter the height of the spring at maximum compression |
|
Working Length |
Either specify the spring working length value, or click and drag a spring control point to define the length graphically
|
|
Spiral |
Select either a Left Hand or Right Hand spiral direction |
|
Display (2D only) |
Select a display mode for 2D springs
|
|
Draw Center Line (2D only) |
Draws the spring with center line(s) |
Potrzebujesz więcej informacji? Poproś o pomoc naszego wirtualnego asystenta Dexa! 